Browse: Models Publications Creators Articles
Twist Lamp Alternate Names:
Twist Lamp
facebook share
Matthew Gardiner
Matthew Gardiner
Paper: Other
Pieces: 1
Cuts: No
Glue: Yes
Rating (Average)

3.0000 (1 ratings)
Difficulty (Average)

3.0000 (1 ratings)

About this Model
This model is on page 5 of the Lighting Section of the binder. It uses a variation of a yoshimura pattern and is designed to form a spiral. The author recommends making this lamp from a thin-sheet plastic like polypropylene, using a 50cm by 30cm (19.68in by 11.81in) rectangular sheet. Note that incandescent bulbs are NOT recommended for use with this design due to fire hazard.
Instructions may be found in the following
Designer Origami : page 0.

Designer Origami
Page 0 (9 Steps)

Diag:Yes CP:Yes Video:No
Photo Gallery
This model has no photos yet